AIO Air Injection Oxidizing Water Filter System 10" x 54"- Iron, Sulfur, and Manganese Removal | Fleck 2510SXT - Katalox Light
- High flow for larger homes, 3 or more people, 2 or more bathrooms
- Highest removal of both iron and sulfur. No chemicals. Nothing to add, all automatic
- Air injection creates pocket of air to super oxidize your water for optimal filtration
- Remove iron up to 23 ppm, Sulfur up to 13 ppm, Manganese up to 8 ppm
- Easy to install yourself with DIY instructions on web. 10" x 54" high flow system 3/4" or 1" bypass
Single Tank Design
By creating a pocket of air at the top of the tank, the treatment process takes place in a single tank. This eliminates the need for a separate tank or pump and reduces wear on the system by removing the contaminants immediately after oxidation.
2510SXT Air Injection Control
Automatic backwashing digital SXT controller on the dependable 2510 valve provides ease of use and low maintenance. Specially setup for air injection to add air without a separate pump.
Filter media for trapping the iron and sulfur
The filter media in the tank traps the oxidized iron and sulfur until it is washed down the drain during the backwash cycle. The filter media will last 5 years on average and is easy to change when needed. Other filter media can be used for specific applications if needed in the future.
Complete system includes the tank, media, riser with distributor, 2510SXT Air Injection head, and bypass valve.
Note: Tank color may vary.
A patented oxidizing system to remove highest levels of iron and sulfur. No chemicals, simple to use, rated best iron filter 8 years in a row. Iron is a common problem in homes today. It causes red staining on fixtures. High flow unit for larger homes, higher water use, 10x54 tank Sulfur is easily detected by the presence of a rotten egg odor, and is sometimes associated with yellow staining. Manganese is most often seen as a black slimy substance that builds in standing water, and may impart a metallic taste to the water. All of these problems can be eliminated with our Air Injection System.
Using the principle of oxidation, the system forces the contaminates into contact with oxygen. Most older air injection systems consist of either two separate tanks or by using a Venturi valve to inject air into the water. cleaned and/or replaced. By utilizing a patented piston, our Air Injection system is able to put the whole oxidation process inside one tank, keeping maintenance costs and down time to a minimum. This is done by creating a bubble of pressurized air at the top of the tank (done during the backwash cycle). The air in the tank then oxidized the contaminates, with the high capacity brand media continues to oxidize and trap, then backwashes off to clean and start over.
|Brand||Oceanic Water Systems|