Chrome Reverse Osmosis 1/2" MIP x FIP Feed Water Adapter Diverter Valve Fits 1/4" Tube

Special Price $6.99 Regular Price $7.99
In stock
SKU
CFWA
  • FEED WATER ADAPTER, made from safe, non-toxic materials that have been tested.
  • Easy to Install, Provides quick and convenient assembly-saving time & expense.
  • Our parts are compatible with Reverse Osmosis & related products. C
  • Fits 1/4" Tube
  • 60mm 1/2" MIP x1/2"FIP

NPT pipe threads - dimensions according ANSI/ASME B1.20.1

common American National Standard Pipe Taper Threads

 

  • NPT - National Pipe Thread Taper
  • NPTF - Dryseal American National Standard Taper Pipe Thread (ANSI B1.20.3)

 

NPT threads may be referred to as MPT ('Male Pipe Thread'), MNPT, or NPT(M) for male (external) threads, and FPT ('Female Pipe Thread'), FNPT, or NPT(F) for female (internal) threads. Note that FPT and MPT are not authorized designations per the ANSI standard.

For NPT threads a sealant compound or Teflon tape must be used for a leak-free seal. For NPTF no sealant is needed for a leak thight connection.

Characteristics of NPT (also known as ANSI/ASME B1.20.1 Pipe Threads, General Purpose):

 

  • tapered thread 1o 47'
  • truncation of roots and crests are flat
  • 60o thread angle
  • pitch is measured in threads per inch

 

Note! Pipe sizes do not refer to any physical dimensions. The outside diameter of a pipe or fitting must be measured and compared to a table for size identification. A 3/4" NPT pipe thread has an outside diameter - OD - of 1.050 inches.

Each thread size has a defined number of threads per inch - TPI, or pitch. The 3/4" NPT pipe thread has 14 threads per inch. Both the TPI and OD of the thread are required for positive identification of thread size because more than one size have the same TPI.

NPT threads are not interchangeable with NPS - National Pipe Straight - threads.

NPT threads may look similar to ISO 7/1 threads. However, ISO and NPT threads should not be mixed. ISO threads have 55o taper angle versus 60o for NPT. The NPT root and crest configurations are also different from ISO. For ISO threads pitch is usually measured in millimeters (may be expressed in Inch). The pitch are different.

More Information
Model Number CFWA
UPC 0
Brand 0
Item Number 0
Shipping Length 0
Shipping Width 0
Shipping Height 0
Shipping Weight 0
Write Your Own Review
You're reviewing:Chrome Reverse Osmosis 1/2" MIP x FIP Feed Water Adapter Diverter Valve Fits 1/4" Tube
Your Rating
All Rights Reserved 2022 -2023 Oceanic Water Systems